Adding A Pc Based N2Kserver; To The Network - Linksys E2500 Configuration Manual

Linksys® E2500 Wireless-N Router Configuration Guide
2.3

Adding a PC based N2KServer

In addition to the PC connected to the WiFi/Router used to configure the WiFi/Router, also
connect the PC slated to run the N2KServer
cable plugs into one of the blue Ethernet sockets at the back of the WiFI/Router.
Now we want to get the MAC address of the PC running N2KServer
an IP Address for it. Having a constant, reserved IP Address for N2KServer
®
N2KView clients to find N2KServer
192.168.1.3 for the N2KServer
®
N2KServer , then each one must have a unique reserved address, but this is beyond the
scope of these instructions, so please contact Maretron Technical Support for assistance.
Inside the WiFi/Router is a DHCP Server, which is responsible for assigning IP addresses to
other network devices that request them. DHCP stands for Dynamic Host Configuration
Protocol.
The PC running N2KServer
From the Basic Setup page, open the DHCP Reservation Table by pressing the DHCP
Reservation button.
Page 12
®
to the WiFi/Router using an Ethernet Cable. The
®
on the network. We will choose to use the address
®
. Note that if you have more than one IPG100 or PC-based
®
on the network will be identified by name of the PC.
®

to the Network.

®
, so that we can reserve
®
, makes it easy for
Revision 1.0