Adding A Mbb100 N2Kview Client To The Network - Linksys E2500 Configuration Manual

Linksys® E2500 Wireless-N Router Configuration Guide
Press Add Client to add the PC to the table.
Press Save Settings and then Close.
To make these settings take effect, disconnect and then reconnect the Ethernet cable to the
PC.
®
Note that if the PC containing N2KServer is the same PC that you are working on, your
session will be disconnected as the PC is given its new address.
2.4

Adding a MBB100 N2KView Client to the Network

Connect Maretron's Black Box (MBB100) to the WiFi/Router using an Ethernet Cable. The
cable plugs into one of the blue Ethernet sockets at the back of the router.
Open the Configuration Dialog on the MBB100 by clicking on the Configuration tab on the right
of the screen. In the Network Configuration section, ensure that the Use DHCP box is
selected. If it is not, click on the square to display the check mark and press the Update button.
The screen may blank for a couple of minutes while the change is applied.
Close the Configuration Dialog and open the Connections Dialog by clicking on the
Connections tab on the right of the screen.
In the N2KServer Connection section, press the Disconnect button, type the IP address of the
IPG100 or PC-based N2KServer.
Page 14 Revision 1.0