Sony Bravia KDL-37S4000 Operating Instructions Manual page 38

Condition
Sound
The picture is good, but there
is no sound.
Channels
You cannot select your desired
channel.
Some channels are blank.
You cannot view digital
channels.
General
The TV turns off
automatically (the TV enters
standby mode).
The TV turns on
automatically.
Some input sources cannot be
selected.
The remote does not function. • Replace the batteries.
You cannot add a channel to
the Favourite list.
HDMI equipment does not
appear on "HDMI Device
List".
You cannot select "Off" in
"Control for HDMI".
Not all channels are tuned for
cable.
The auto tuning procedure
takes a long time.
38
GB
Explanation/Solution
• Press 2 +/– or % (Mute).
• Check if the "Speaker" is set to "TV Speaker" (page 30).
• When using HDMI input with Super Audio CD or DVD-Audio,
DIGITAL AUDIO OUT (OPTICAL) may not output audio signals.
• Switch between digital and analogue mode, and select the desired
digital/analogue channel.
• The channel is for scrambled/subscription service only. Subscribe to a
pay TV service.
• The channel is used only for data (no picture or sound).
• Contact the broadcaster for transmission details.
• Contact a local installer to find out if digital transmissions are provided
in your area.
• Upgrade to a higher gain antenna.
• Check if the "Sleep Timer" is activated, or confirm the "Duration"
setting of "On Timer Settings" (page 28).
• Check if the "On Timer Settings" is activated (page 28).
• Select "Video Labels" and cancel the "Skip" setting for the input source
(page 30).
• Up to 999 channels can be stored in the Favourite list.
• Check that your equipment is compatible with control for HDMI.
• If you have connected any audio system that is compatible with control
for HDMI, you cannot select "Off" in this menu. If you want to change
the audio output to the TV speaker, select "TV Speaker" in the
"Speaker" menu (page 30).
• Check the support website for cable provide information.
http://www.sony-asia.com/bravia/flash.html
• If you have connected the VCR to the TV, we recommend inserting a
pre-recorded tape into a VCR before you start auto tuning for fast tuning.
Cancel the auto tuning, and insert a pre-recorded tape into a VCR
connected to the TV. Then select "Auto Start-up" (page 29) to make the
initial set-up again.