Lorex Live LNC100 Series User Manual page 78

L-View for Mac
To configure general video settings:
1. Right-click the camera in Camera List and click Video settings. Then, select the
Video tab.
2. Under Video Color, select Colored or Black & White.
3. Under Sharpness, select the sharpness of the image between 10 (highest) and 1
(lowest).
4. Under Place, select Outdoor if the area with the camera is brightly lit. Select Indoor
if you notice strip lines in the image or if the picture is too dark on the Outdoor video
setting. Select Indoor + Sunlight if the picture is too bright on the Indoor setting.
• If you select Indoor or Indoor + Sunlight, select 60Hz or 50Hz under Light Frequency
to adjust the camera for the frequency of your indoor lighting.
5. Under Video Flip, select Flip to flip the camera image vertically and horizontally or
select Normal for normal orientation.
6. Under Brightness, select the brightness of the image between 10 (highest) and
1 (lowest).
7. Under Low Light Sensitivity, set the camera's sensitivity in low light environments
between Very High (highest), High, and Normal (lowest).
8. Check Enable time display on video to turn on video time stamps or un-check it to
disable video time stamps.
9. Under Microphone, select Enabled to enable the built-in microphone on the camera
or select Disabled to disable the built-in microphone on the camera.
10.Click Update to save changes. Enter the camera admin user name (default: admin)
and password (default: left blank) and click OK. Click OK to exit the settings window.
NOTE: The camera may reboot after settings are changed. Wait about 30 seconds and
then double-click the camera in Camera List or Auto Search to reconnect to the camera.
62