System Information And Reset Tv; Selecting The External Input Source To View - Toshiba Esteem 399 User Manual

2
Select Over-the-air Upgrade menu and press
OK.
3
Press  or  to select Search for New
Software.
4
Press OK. The television will automatically start
searching for a software upgrade, the progress
bar will move along the line.
If an upgrade is found, a message will be
displayed on the television. Follow the
instructions in the message. If no upgrades
are found, a screen will appear stating that no
upgrades are available.
NOTE:
Searching for software upgrades and upgrading may
take a long time.
Viewing the Software Licences
The licences for the software used in this TV are
available for viewing on screen.
1
From the SETUP menu, press  or  to select
Software Licences.
2
Press OK.
A screen will appear displaying all of the
licencing information required for the TV's
software.

System Information and Reset TV

Confi rming software version
This feature can be used to check the version of
software currently installed. When in DTV mode,
it includes additional diagnostic information such
as signal strength, signal quality, centre frequency,
modulation, etc
1
From the SETUP menu, press  or  to select
System Information.
2
Press OK to display the Boot Code Version and
APP SW Version..
System Information
TOSHIBA 2014
ID: XX
Boot Code Version: XXXX.XXXX.XXXX
APP SW Version: XXXXXX
WEAK AVERAGE
CH22
CH25
CH16
CH11
3
For information about the signal quality of a
particular multiplex, press  or  to select that
multiplex.
Using the TV's features
4
Press OK for a screen showing detailed technical
information about the selected multiplex.
Resetting the TV
Reset TV will reset all TV settings, including stored
channels, to their original factory values.
1
From the SETUP menu, press  or  to select
Reset TV.
2
Press OK to select.
A screen will appear warning that all settings
will be lost. Select Yes, and then press OK to
continue.
When the set powers back on, the fi rst time
screen will appear (- page 11). Press OK
to continue, and proceed to the Auto Tuning
menu (- page 14).

Selecting the external input source to view

1
Press o on the remote control until the
external input mode list appears on the screen,
then press ,  or o to select appropriate
input source.
2
Press OK.
VIDEO (o standard video input) ,
HDMI (HDMI input)
NOTE:
If the Inputs list is displayed by pressing p / o and U
or u on the left side of the TV and U or u, the options
STRONG
are DTV/VIDEO/HDMI/ATV.
GOOD
GOOD
GOOD
GOOD
SETUP
DTV Manual Tuning
DTV Settings
Quick Setup
Location Home
Software Upgrade
Software Licences
System Information
Reset TV
Inputs
TV
VIDEO
HDMI
31