Table of Contents
Advertisement
112
Using the TV's features
Displaying TV status information
NOTE
Setting up HDMI
To set the HDMI
1
From the Setup menu, highlight HDMI
press the ENTER button.
2
Press the ( /
HDMI
Press the ( /
3
NOTE
4
Press the ( /
HDMI
arrow) buttons to select On or the desired mode.
O
O
O
O
5
To save the new settings, highlight Done and press the ENTER
button.
To revert to the factory defaults, highlight Reset and press the
ENTER button.
Displaying TV status information
To display TV status information using the RECALL button:
Press the RECALL button on the remote control.
O
The following information will be displayed (if applicable):
Current input (ANT/CABLE, Video, etc.)
O
If ANT/CABLE is the current input, either "CABLE" (for
O
cable TV) or "ANT" (for over-the-air broadcasts).
Channel number (if in ANT/CABLE mode)
O
When you turn on the Audio Receiver, change its input source or
adjust the sound volume, the sound will be output from the audio
receiver's speakers even if TV Speakers has been selected. Turn the
TV off and on again to output the sound from the TV speakers.
®
-CEC
®
-CEC Setup:
arrow) buttons to highlight Enable
®
-CEC.
arrow) buttons to select On.
If you select Enable HDMI
out.
arrow) buttons to highlight the
®
-CEC Setup item you want to use, and press the ( /
TV Auto Input Switch: On/Off
TV Auto Power: On/Off
Device Auto Standby: On/Off
Speaker Preference: TV Speakers/Audio Receiver
®
-CEC Setup and
-CEC Off, the other items will be grayed
®
Advertisement
Table of Contents
