Transferring Data - Sharp ZQ-570 Operation Manual

Transferring Data

There are several ways to transfer information -whether specific
entries or entire files - between the Organizer and other
information processing devices, including personal computers
and other SHARP Organizers. In this way, you can back up
your information to guard against losing it, or copy information
so that you or someone else can work with it on another device.
A summary of transfer devices, transferable data, and tasks to
which a transfer device is most suited is provided in the table
below.
Depending upon the SHARP or third-party software you
are using, some features and capabilities may vary.
78
The Auto power off function (see p.12) is disabled in all
transfer modes.
When transferring data from other models, only entries in a
mode (application) supported on the ZQ-570 Organizer can
be sent.
Transferring between two ZQ-570 Organizers
Data can be transferred directly between two ZQ-570
Organizers via a 4-pin cable. Single entry or all the entries in
an application can be transferred in the Schedule, To Do, Ann,
Memo, Expense, Tel and User File applications.
The transfer procedure diiers according to
or complete files are to be transferred.
Press [ON] at any time to interrupt and cancel a transfer.
*
After a transfer, the display returns to the application being
used before the transfer procedure was begun.
To set up the Organizers for data transfer via 4-pin cable:
1. Turn off both Organizers.
2. Open the cover of the 4-pin cable jack on each Organizer.
Plug each end of the cable into the jack on each Organizer.
3.
whether
single entry