In The Box; Quick Setup; Getting Started - NAD D 3020 Owner's Manual

INTRODUCTION

GETTING STARTED

UNPACKING AND SETUP
WHAT'S IN THE BOX
Packed with your D 3020 you will find:
• Detachable mains power cord
• Remote control with 3V CR2025 battery
• TOSLINK mini-adapter
• Four pieces of dome-shaped feet
• Quick Setup Guide
SAVE THE PACKAGING
Please save the box and all the packaging in which your D 3020 arrived.
Should you move or otherwise need to transport your D 3020, this is by
far the safest container in which to do so. We've seen too many otherwise
perfect components damaged in transit for lack of a proper shipping
carton, so please: Save that box!

QUICK SETUP

This simple guide will help you get started with your D 3020.
Place the D 3020 on a firm, level surface. Do not place the unit on a soft
surface like a carpet.
Make all the connections to your D 3020 with the unit unplugged from
the mains power source. It is also advisable to power down or unplug all
associated components while making or breaking any signal or AC power
connections.
1 Using applicable connectors (not supplied), connect source devices to
corresponding input sockets of D 3020.
S/PDIF sources $ OPTICAL 1, OPTICAL 2, COAXIAL
Analog sources $ AUX 1, AUX 2
USB device $ USB
Other sources $ Bluetooth
2 Using applicable connectors (not supplied), connect the digital audio
input and analog audio input ports to the corresponding audio input
sockets of other devices like receivers, amplifiers, audio processors or
music system.
3 Connect corresponding end of the mains power cord to the AC mains
input of the D 3020 and the plug connected to a mains power source.
4 With all applicable sources hooked up with D 3020 and powered up,
press (Standby) to switch ON the D 3020 from standby mode.
5 Start listening to your preferred Source by repeatedly pressing "S" to
cycle through the Sources (OPTICAL 1, OPTICAL 2, COAXIAL, USB, AUX 1,
AUX 2 and BT) and select desired Source.
4