Av tuner receiver / 5 and 7-channel power amplifier / dvd/sacd player / av surround sound receiver / dvd/cd players / dvd/cd/mp3 player / av surround sound receiver / stereo integrated amplifier / cd player (20 pages)
IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS FOR LATER USE. 15 Lightning - For added protection for this product during a lightning storm, or FOLLOW ALL WARNINGS AND INSTRUCTIONS MARKED ON THE AUDIO when it is left unattended and unused for long periods of time, unplug it from the EQUIPMENT.
Page 3
RECORD YOUR MODEL NUMBER NOW, WHILE YOU CAN SEE IT THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN The model and serial number of your new D 3020 are located on the back of the EQUILATERAL TRIANGLE, IS INTENDED TO ALERT THE USER TO THE cabinet.
QUICK SETUP This simple guide will help you get started with your D 3020. Place the D 3020 on a rm, level surface. Do not place the unit on a soft surface like a carpet. Make all the connections to your D 3020 with the unit unplugged from the mains power source.
With the corresponding end of the mains power cord connected SUBW OUT to the AC mains input of the D 3020 and the plug connected to a mains power source, press o (Standby) to switch ON the D 3020 •...
Page 6
PCM before connecting to the digital audio input of D 3020. 14 SERVICE • Use this port only for rmware upgrade. Instructions on how to use this port for rmware upgrade is included in the D 3020 rmware upgrade (if any) procedure available from the NAD website.
CONDITIONS FOR AUTO SENSE • listed in your Bluetooth settings. Pair or connect together your D 3020 For Auto Sense to work, Auto Standby must be set to ON with D 3020 and Bluetooth device. going rst to standby mode.
Page 8
• Perform the same operation to learn “Volume-“, “Mute” and ”Power D 3020 can also be awakened by pressing the top panel’ s o and the power ON” respectively as per IR LEARNING PROCEDURE below. ON button of either AMP 3 remote control or TV’ s remote control.
Page 9
You may generate a template for proper placement of the feet. NOTES • The feet can only be installed in the format shown above. • Ensure that with the feet installed, the D 3020 is stable, balanced and will not tip over.
Neumann cutting lathes. NAD SHALL NOT BE HELD LIABLE FOR ANY TECHNICAL OR USER INTERFACE DISCREPANCIES IN THIS MANUAL. THE D 3020 OWNER’S MANUAL MAY BE SUBJECT TO CHANGE WITHOUT NOTICE. CHECK OUT WWW.NADELECTRONICS.COM FOR THE LATEST VERSION OF THE D 3020 OWNER’S MANUAL.
Page 12
All rights reserved. NAD and the NAD logo are trademarks of NAD Electronics International, a division of Lenbrook Industries Limited. No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International.