NAD 7050 Owner's Manual

NAD 7050 Owner's Manual

Direct digital network amplifier
Hide thumbs Also See for 7050:

Advertisement

D 7050
®
Direct Digital Network Amplifier
Owner's Manual

Advertisement

Table of Contents
loading

Summary of Contents for NAD 7050

  • Page 1 D 7050 ® Direct Digital Network Amplifier Owner’s Manual...
  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS FOR LATER USE. NOTE TO CATV SYSTEM INSTALLER FOLLOW ALL WARNINGS AND INSTRUCTIONS MARKED ON THE AUDIO This reminder is provided to call the CATV system installer’s attention to Section 820-40 EQUIPMENT. of the NEC which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as Read instructions - All the safety and operating instructions should be read close to the point of cable entry as practical.
  • Page 3 RECORD YOUR MODEL NUMBER (NOW, WHILE YOU CAN SEE IT) PRESENCE OF UNINSULATED “DANGEROUS VOLTAGE” WITHIN THE The model and serial number of your new D 7050 are located on the back of the PRODUCT’S ENCLOSURE THAT MAYBE OF SUFFICIENT MAGNITUDE TO cabinet.
  • Page 4: In The Box

    QUICK SETUP This simple guide will help you get started with your D 7050. Place the D 7050 on a firm, level surface. Do not place the unit on a soft surface like a carpet. Make all the connections to your D 7050 with the unit unplugged from the mains power source.
  • Page 5: Identification Of Controls

    PRE OUT or SUBWOOFER terminals. • AUTO SHUTOFF in the D 7050 app is set to “OFF” or no D 7050 app is used Always turn OFF the D 7050 and associated external devices before to control the D 7050 connecting or disconnecting anything to the AUDIO OUT sockets.
  • Page 6 • Using a standard straight-through Ethernet cable (not supplied), connect one end of the Ethernet cable to the LAN port of your wired Ethernet broadband router and the other end to D 7050’ s LAN port. 11 DOCK • Applicable for direct playback only of iOS device. Using applicable Apple USB connector, connect your iOS device to this input.
  • Page 7 Ensure that your Apple iOS device (iPod, iPad, iPhone) controller is connected to the same network as the D 7050. If they are not on the same network, the D 7050 app will just be in Demo Mode. The user can simulate the selection of the features and settings at Demo Mode but no actual command is transmitted or sent.
  • Page 8 IMPORTANT NOTES ABOUT POWER SAVE SETTINGS • If D 7050 is switched to standby mode with POWER SAVE set to ON, the D 7050 will go to Demo Mode. At this condition, the D 7050 cannot be switched back to operating mode using the D 7050 app. Press  (Standby) switch or ON from the remote control to switch D 7050 to...
  • Page 9 2 OFF: Switch D 7050 to standby mode. 3 +/- : Increase or decrease audio level. 4 t u : Select source. 5 Applicable for Airplay mode and for Tuner Controls of NAD products with Tuner section AIRPLAY MODE ]: Pause or resume playback of current song; if applicable, pause or resume broadcast.
  • Page 10: Setting Up Network Connection

    ACCESS POINT MODE AirPlay lets you stream music from your AirPlay-enabled device to the The D 7050 can act as an Access Point (AP) enabling it to connect to a wired D 7050. The AirPlay-enabled device and the D 7050 must be in the same network wirelessly.
  • Page 11: Share Wifi Settings

    1 Using applicable Apple USB cable (not supplied), connect iOS device to DOCK input at the rear panel of D 7050 to share WiFi settings. 2 Short press WPS button located at the rear panel of D 7050. A flashing signal strength bar indicator appears in the upper right corner of the D 7050 display.
  • Page 12 OTHER FEATURES DLNA 3 After turning on media streaming, select desired song from the library. The Digital Living Network Alliance (DLNA) is a cross-industry organization Right click the desired song, select “Play to” and then assign to “D7050AP of consumer electronics, computing industry and mobile device xxxxxx”.
  • Page 13 You may generate a template for proper placement of the feet. 184,5 NOTE 58,0 Ensure that with the feet installed, the D 7050 is stable, balanced and will not tip over. 185,8...
  • Page 14: Specifications

    3.3 kg (7.3 lbs) NAD SHALL NOT BE HELD LIABLE FOR ANY TECHNICAL OR USER INTERFACE DISCREPANCIES IN THIS MANUAL. THE D 7050 OWNER’S MANUAL MAY BE SUBJECT TO CHANGE WITHOUT PRIOR NOTICE. CHECK OUT WWW.NADELECTRONICS.COM FOR THE LATEST VERSION OF THE D 7050 OWNER’S MANUAL.
  • Page 16 All rights reserved. NAD and the NAD logo are trademarks of NAD Electronics International, a division of Lenbrook Industries Limited. No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International.

Table of Contents