Table of Contents
Advertisement
Storage
STORAGE
See General Warnings on page 8.
DANGER
• Do not attempt to drain fuel when the engine is hot or while it is running.
• Clean up any spilled fuel before operating the vehicle.
• Store fuel in an approved fuel container only. Store in a well-ventilated area away from sparks, open
flames, heaters, or heat sources.
• Keep fuel out of the reach of children.
• Do not siphon fuel from the vehicle.
WARNING
• Turn the key switch to the OFF position, remove the key, and leave the Forward/Reverse handle in
the NEUTRAL position during storage. This is to prevent unintentionally starting the vehicle or a
fire hazard.
• Do not attempt to charge frozen batteries or batteries with bulged cases. Discard the battery. Frozen
batteries can explode.
CAUTION
• Batteries in a low state of charge will freeze at low temperatures.
PREPARING THE VEHICLE FOR EXTENDED STORAGE
1.
Unload the vehicle so that the tires are supporting only the weight of the vehicle.
2.
Store the vehicle in a cool, dry place. This will minimize battery self-discharge. If the battery appears to be weak,
have it charged by a trained technician. Use an automotive-type 12-volt battery charger rated at 10 amps or
less. Check electrolyte level after charging and add distilled water if necessary. If the battery is dead, see
Using A Booster Battery (Jump Starting) on page 46.
3.
Make sure the key switch is in the OFF position and the Forward/Reverse handle is in the NEUTRAL position.
Chock the wheels.
4.
Diesel vehicles: If Biodiesel fuel is used, see Biodiesel Fuel (Diesel Vehicles Only) on page 42. Prepare
the fuel tank.
4.1. Fill the fuel tank with fresh fuel.
4.2. Disconnect the fuel vent line from the fuel tank vent nipple (Figure 26).
4.3. Plug the fuel tank vent nipple so that it is air tight. Husqvarna recommends using a slip-on vinyl cap.
5.
Change engine oil. See Engine Oil and Filter Change on page 36.
6.
Disconnect battery. See Disconnecting the Battery – Diesel Vehicles on page 10.
7.
The battery should be clean and free of corrosion. Wash the battery top and terminals with a solution of baking
soda and water (1 cup (237 mL) baking soda per 1 gallon (3.8 L) of water). Rinse the solution off the battery. Do
not allow this solution to enter the battery. Be sure the terminals are tight. Let the terminals dry and then coat
them with Battery Terminal Protector Spray (P/N 603 00 00-03).
8.
Adjust the tires to the recommended tire pressure. See Vehicle Specifications on page 49.
9.
Perform semiannual periodic lubrication. See Periodic Lubrication Schedule on page 33.
10. Thoroughly clean the front body, rear body, seats, cargo bed, engine compartment, and underside of vehicle.
Page 28
HUV 5420 DX All-Wheel Drive CE Mark Diesel Vehicle Owner's Manual
Advertisement
Table of Contents
