Table of Contents
Advertisement
Driving Instructions
WARNING
• To help prevent overturning the vehicle, drive slowly straight up and down slopes. Avoid driving
the vehicle on slopes exceeding 20% incline.
• Avoid stopping a loaded vehicle on a hill. If a loaded vehicle must be stopped on a hill, avoid
sudden starts or rolling backwards and stopping suddenly. Failure to heed this warning could result
in overturning the vehicle.
• To help avoid possible injury to inattentive passengers and (or) damage to the vehicle, avoid sudden
starts, sudden stops, and abrupt turns.
• To help avoid the possibility of losing control of or overturning the vehicle, reduce speed for adverse
driving conditions such as wet grass or rough terrain.
• The vehicle should be driven in only specified areas by trained drivers.
• Do not drive while under the influence of alcohol, drugs, or medications.
• Use brakes to reduce speed when coasting downhill.
• Never attempt jumps.
• Keep away from drop-offs, steep slopes, and unstable surfaces.
• Avoid extremely hard braking in reverse.
No one should drive the vehicle without first being instructed in the proper operation and use of vehicle controls. An
experienced operator should accompany each first-time driver on a test drive before allowing the driver to operate
the vehicle alone.
To ensure safe operation of the vehicle, follow exactly and in order all of the following procedures. Read and
understand all instructions before driving the vehicle.
STARTING THE VEHICLE
1.
Read safety warnings on the instrument panel and vehicle loading information located in the cargo bed.
2.
Be sure load, if any, is secure.
3.
Study and understand all controls.
4.
Be sure all passengers are seated with their seat belts fastened and are holding on to hand holds. Driver should
have both hands on the steering wheel.
5.
Make sure wheels are turned in desired direction and nothing is in your path.
6.
Make sure the Forward/Reverse handle is in the NEUTRAL position.
7.
Press and hold the brake pedal.
8.
Start the vehicle.
8.1. To preheat glow plugs in cold weather, turn the key to the PREHEAT position and hold it there for 10-15
seconds. Turn the key to the START position and hold it there until the engine starts. If the engine does not
start after 10-15 seconds, turn the key to the OFF position and repeat the procedure. Once the engine
starts, release the key and it will return to the ON position. The engine will idle in neutral.
9.
Release the park brake.
10. Keep the brake pedal engaged, and select direction of travel by placing the shift handle in the desired position
(Figure 7). The engine must be at idle before the shift handle is moved. A buzzer will sound as a warning when
the Forward/Reverse handle is in the REVERSE position.
11. Release the brake pedal completely, and then slowly press the accelerator pedal. As the accelerator pedal is
pressed, the vehicle will begin to move. Vehicle speed will increase as the accelerator is pressed until full speed is
reached. All-wheel drive will automatically drive the appropriate wheel(s) as required. See following WARNING.
Page 22
HUV 5420 DX
Homologated Diesel Vehicle for Europe Owner's Manual
R
Advertisement
Table of Contents
