Panasonic Diga DMR-EH50 Operating Instructions Manual page 15

Connecting a television with 21-pin Scart terminal and VCR
When there is no 21-pin Scart terminal on the television (
≥This unit is compatible with timer recording using the programme function on television (e.g., a IDTV) (
≥The AV2 or AV4 Scart terminals on Panasonic televisions are compatible with the Q Link functions.
indicates included accessories.
indicates accessories not included.
are required connections. Connect in the numbered order.
1 4
To the aerial
VHF/UHF
RF IN
Splitter
Aerial
cable
RF coaxial cable
1
2
RF OUT RF OUT RF IN RF IN
This unit's rear panel
21-pin Scart cable
Use a splitter if you
also want to
connect the aerial
to your VCR.
VHF/UHF
RF IN
∫ RGB
This refers to the three primary colours of light, red (R), green (G), and blue (B) and also the method of producing video that uses them. By
dividing the video signal into the three colours for transmission, noise is reduced for even higher quality images.
16)
AV IN
Fully wired 21-pin
3
Scart cable
S VIDEO OUT S VIDEO OUT
VIDEO VIDEO
L L
AV1 ( TV )
AUDIO AUDIO
S VIDEO S VIDEO
R R
AV4 IN AV4 IN
AV2 ( DECODER/EXT )
AV4 IN AV4 IN OUT OUT
AV1 terminal
≥If your television is equipped with RGB input capability, by
connecting with a fully wired 21-pin Scart cable you can see
video using RGB output on this unit (
To output in RGB select "RGB (without component)" from "AV1
Output" in the SETUP menu (
( 18, 19).
≥If your television is equipped with Q Link functions, by
connecting with a fully wired 21-pin Scart cable you can use
these functions (
AV OUT
Television's
rear panel
Connect only after all other
connections are complete.
Y P P
B R
OPTICAL OPTICAL
COMPONENT COMPONENT
VIDEO VIDEO OUT OUT
(PROGRESSIVE/ (PROGRESSIVE/ DIGITAL AUDIO OUT DIGITAL AUDIO OUT
INTERLACE) INTERLACE) (PCM/BITSTREAM) (PCM/BITSTREAM)
below).
57) after tuning is completed
69).
VCR's rear panel
29).
To household mains socket
(AC 220–240 V, 50 Hz)
AC mains lead
4
Cooling fan
AC IN
RQT8027
15