Flash-To-Pass; Windshield Wipers - Chevrolet Malibu 2007 Owner's Manual

Flash-to-Pass

This feature lets you use your high-beam
headlamps momentarily to signal a driver in
front of you that you want to pass.
To use it, pull the turn signal/multifunction lever
toward you until the high-beam headlamps
come on, then release the lever to turn them off.

Windshield Wipers

Be sure to clear ice and snow from the wiper
blades before using them. If the wiper blades
are frozen to the windshield, gently loosen or thaw
them. If the blades do become damaged, install
new blades or blade inserts. See Windshield Wiper
Blade Replacement on page 394.
Heavy snow or ice can overload the wiper motor.
A circuit breaker will stop the motor until it
cools down. Clear away snow or ice to prevent
an overload. If the wipers gets stuck, turn
the wipers off, clear away the snow or ice,
and then turn the wipers back on.
Use this lever, located on the right side of the
steering wheel, to operate the windshield wipers.
(High Speed): Move the lever to this
1
position for steady wiping at high speed.
(Low Speed): Move the lever to this
6
position for steady wiping at low speed.
(Delay): Move the lever to this position to
&
set a delay between wipes.
173