Goodman GKS9 Installation Instructions Manual page 19

mounting).
2. Secure Hose A to front cover drain port with a red hose
clamp. Route hose to rear side panel grommet hole.
NOTE: For left side drainage, grommets will have to be relocated
to left side panel.
3. Cut and remove 1/4 inch from the end of the drain port on
the rubber elbow.
4. Insert Tube 1 into rubber elbow drain port and secure with
silver hose clamp. Angle tube outward toward front of
furnace.
5. Right side drains
Cut 17 3/4 inches from the long end (end opposite the
bend) of Hose B. Save the part with the bend and discard
the 17 3/4 inch piece that was cut. Secure the remaining
hose to Tube 1 with a green hose clamp. Route the other
end of Hose B to front right side panel grommet hole.
RED HOSE
RED HOSE
FRONT COVER
CLAMP
DRAIN PORT
Upright "Standard" Connections - Right Side
LEFT
SIDE PANEL
FRONT COVER
DRAIN PORT
CLAMP
HOSE A
SIDE PANEL
DRAIN
HOLES
TUBE(S) 2
DRAIN
TRAP
Upright "Standard" Connections - Left Side
Left side drains
Cut "X" inches from the long end of Hose B and discard.
Refer to table for appropriate length to cut. Secure remaining
hose to Tube 1 with a green hose clamp. Route other end
of Hose B to front left side panel grommet hole.
Cabinet Width
(inches) (kBTU_Tons)
17 1/2
21
24 1/2
RIGHT SIDE
PANEL
RUBBER ELBOW
DRAIN PORT
SILVER HOSE CLAMP
HOSE
SIDE PANEL
B
GROMMET
HOSE
A GREEN
HOSE
CLAMPS
(3 PLACES)
GREEN HOSE
HOSE B
19
Models "X" Length to Cut From Long
End of Hose B
045_30
7 inches
070_30
070_40
3 1/2 inches
090_40
090_50
None
115_50
RUBBER
ELBOW
TUBE 1
HOLES
TUBE(S) 2
DRAIN
TRAP
RUBBER
ELBOW
RUBBER
ELBOW
DRAIN PORT
SILVER HOSE
CLAMP
TUBE 1
CLAMPS
(3 PLACES)