Problem Solving
Check
Is the correct setting for the remote receiver selected?
Other Problems
No sound can be heard or the sound is faint
Check
Check that the audio/video cable is securely attached to both the
projector and audio source.
(EB-X14G/EB-W02/EB-X02/EB-S02 only)
Is the volume adjusted to the minimum setting?
Is A/V Mute active?
Is the audio cable's specification "No resistance"?
(EB-X14G/EB-W02/EB-X02/EB-S02 only)
Is Output audio from the projector selected?
(Only when projecting USB Display)
The remote control does not work
Check
Is the remote control light-emitting area pointing towards the
remote receiver on the projector during operation?
Is the remote control too far from the projector?
Check the Remote Receiver from the Configuration menu.
s Settings - Remote Receiver
p.59
Disconnect the cable from the Audio port, and then reconnect the cable.
Adjust the volume so that sound can be heard.
s Settings - Volume
p.59
s "Adjusting the Volume"
p.37
Press the [A/V Mute] button on the remote control to cancel A/V Mute.
s "Hiding the Image and Sound Temporarily (A/V Mute)"
When using a commercially available audio cable, make sure it is labeled "No resistance".
Click All Programs - EPSON Projector - Epson USB Display - Epson USB Display Vx.xx Settings, and then select
Output audio from the projector.
Point the remote control towards the remote receiver.
s "Remote control operating range"
The operating range for the remote control is about 6 m.
s "Remote control operating range"
Remedy
Remedy
p.43
Remedy
p.17
p.17
76