Demo - Electrolux EWM3500 Service Manual

4.2.11.5 Demo

A special cycle has been created for demonstration of the operation of these appliances in retail outlets without
connecting the appliance to the water supply. In this way, the salesman can select any programme; after
starting the cycle by pressing START, the appliance will perform certain phases only, and will skip those which
cannot be performed (water fill, drain, heating).
The cycle takes place as follows:
the door locking device is actioned in the normal way (i.e. the door remains locked while the appliance is in
operation, and can be opened at the end of the cycle or in pause mode)
motor: all low-speed movements are enabled, while the pulse signals and the spin cycle are excluded
the water fill solenoids and the drain pump are disabled
LCD: it displays all the programme phases rapidly
alarms: for safety reasons the following groups of alarms remain enabled: E40 (door closed), E50 (motor)
and E90 (communication between the boards/configuration).
Push buttons 3 or 4 and scroll down the menu till:
"WASH GUIDE"
Wait two seconds the writing changes to:
"PUSH OK" button 5.
Push buttons 3 or 4 and scroll down the menu till:
"DEMO"
To activate the cycle push button OK (5).
To deactivate this function, just switch the appliance off, or
repeat the DEMO mode and the display shows: DEMO Off.
The MEMO function can be activated continuously: switch the
appliance off, push buttons OK (5) and START/PAUSE (6)
simultaneously, and holding them down turn the selector of
three positions clockwise for five seconds.
To terminate the cycle, repeat the same procedure and DEMO Off will appear.
SOI/DT 2007-02 dmm
24/66
599 38 61-92