Demo Mode - Electrolux EFLS617SIW Technical & Service Manual

Diagnostic System -
NOTE
The door is locked in the test step, however, it can
change without delay in another test step or on
exit from diagnostic mode.
Exit Diagnostic Mode
To return the Washer to normal operation
• Hold the power button for 3 secs when not in '00'
test (Lights / Buttons), or unplug the unit.
Factory Default Reset
1. Press power button for power ON and wait for 10
seconds.
2. Simultaneously hold soil + option buttons for 3
seconds.

13.2 Demo Mode

WARNING
This information is intended for Qualified
Technicians Only.
CAUTION
Disconnect Electric Current Before Servicing.
Demo Mode
The Demo works in two ways: interactive mode and
automatic loop.
1. The interactive mode enables the customer to
use interface without activating the water and heat.
The machine behaviour appears similar to operation.
The start option locks the door, the drum light turns
ON and the ETR is decreased each second. No water
load / drain is executed.
2. If no one interacts with the interface for 3 minutes,
or start button has not been pushed, the machine
goes into an automatic loop instead, simulating the
cycle execution is only on display. This automatic
loop cycle continues until it is interrupted by the user
interface and it goes back to the interactive mode.
EFLS617SIW / EFLS517SIW / EFLS417SIW
Enter Demo Mode:
1.
Power button;
2. Turn the selector to the 6 th position from the top
clockwise;
3. Simultaneously hold temp and set buttons for 3
seconds;
4. The message "dn" blinks 3 times on cycle time
digits;
5. When no acknowledgement is received, switch
the machine OFF and repeat sequence from the
beginning.
Every time the machine is switched ON, Demo mode
is automatically recalled; this occurrence is signalled
at the start-up by the text "dM" blinks 3 times on cycle
time digits. Unplugging the unit will not clear the
DEMO mode.
Exit Demo Mode:
1.
described above or go to the next step.
2. Press the reset combination (soil + options
buttons) anytime.
3. If the action is acknowledged, the machine
reboots in normal mode.
If power is removed during this test, the door can
be opened. To prevent injury, do not put your
hands inside when the tub is rotating.
32
Press power button to switch ON the machine via
Redo the enter demo mode sequence of actions
SAFETY WARNING