Table of Contents
Advertisement
Chapter 3 Installing the DPC2434 and EPC2434 for Telephone Service
Installation Diagram
The following diagram illustrates one of the various connection options that are
available to you.
To install the wireless home gateway for telephone service
1
Connect a telephone, fax machine, or analog modem to each of the appropriate
RJ-11 ports on the wireless home gateway.
Notes:
The wireless home gateway provides one line of telephone service on each of
the RJ-11 connectors.
Service must be set up and enabled by the telephone service provider.
The two center conductors (pins 3 and 4) on the RJ-11 connector provide
electrical connections to directly attached telephone devices or to a
permanently installed in-home telephone wiring network.
The telephone port labeled Line 1 also supports multi-line telephone devices.
Line 1 is supported on pins 3 and 4, and Line 2 is supported on pins 2 and 5.
The use of telephones that require electrical connections to other RJ-11 pins
requires an adapter.
2
After all telephone connections are complete, insert the AC power cord into the
power connector on the back of the wireless home gateway, and then plug the
cord into an AC power source.
34
78-4011351-01 Rev B
Advertisement
Table of Contents
Troubleshooting
