Adjustments; Adjusting Table Positive Stops - Delta Sidekick 36-210 Instruction Manual

ADJUSTING TABLE
POSITIVE STOPS
1. Move the table to the 90 degree straight cut-off po-
sition, making sure the plunger is engaged in the 90
degree positive stop and tighten the lock handle (A) Fig.
21.
2. Make a cut on a piece of wood, as shown in Fig. 21.
3. Using a square, check to see if the piece of wood
was cut at 90 degrees, as shown in Fig. 22.
4. If an adjustment is necessary, loosen the lock handle
(A) Fig. 23, one turn. Then loosen locknut (B) and turn
eccentric nut (C) right or left as necessary and tighten
lock nut (B).
5. Make another test cut and if further adjustment is
necessary, repeat the above instructions.
6. When you are certain the cut is at 90 degrees, adjust
pointer (D) Fig. 24, to point to the "0" mark on the scale,
by loosening set screw (E).
7. Once the 90 degree positive stop is adjusted, the
positive stops at 22-1/2 and 45 degrees right and left will
also be adjusted.

ADJUSTMENTS

12
Fig. 21
Fig. 22
Fig. 23
Fig. 24