Hanging The Fan; Assembling The Fan; Wiring The Fan - Hunter 41877-01 Installation And Operation Manual

Arrows for Orienting
on Angled Ceiling
Figure 8 - Locating the slotted holes to use
6. Place a flat washer on each of the two 3" screws and pass the
screws through the slotted holes in the ceiling plate as shown
in Figure 9.
7. Tighten the screws into the 9/64" pilot holes; do not use lubri-
cants on the screws. Do not overtighten.
2" x 4" Brace
Ceiling Plate
Flat Washer
Figure 9 - Installing the ceiling plate

assembling the fan

assembling the fan for a standard or angled ceiling
1. Insert the pipe through the canopy and adapter cover with
the adapter ring assembled. To keep the adapter ring as-
sembled, twist the adapter cover around the downrod. Refer
to Figure 12. Feed wires from the fan through the downrod.
2. Screw the downrod into the fan assembly until tight. IMPOR-
TANT! Tighten downrod set screw as shown in Figure 10.
CAUTION: The downrod has a special coating on the
threads. Do not remove this coating; the coating prevents
the downrod from unscrewing. Once assembled, do not
remove the downrod.
3. Slide the adapter cover down by twisting it around the
downrod until it is flush to the top of the motor housing.
4. Continue to the hanging the fan section.
41877-01 06/14/2007
Slots
Ceiling Joist
Celing
Outlet Box
3" Wood Screw
Figure 10 - Assembling the downrod

hanging the fan

1. Raise the fan and place the hook through the loop on the ceil-
ing plate as shown in Figure 11. Use the note and arrow en-
graved in the ceiling plate to assist in determining the direc-
tion to assemble.
WARNING: Fan may fall if not assembled as directed in
these installation instructions.
Hook
Figure 11 - Hanging the fan

wiring the fan

1. Disconnect the power by turning off the circuit breakers to
the outlet box and associated wall switch location.
2. You can use either one or two wall switches to control the fan
and/or lights separately. Use connection 1, as described in Fig-
ure 12, to
• control the light with a wall switch and the fan with a pull
chain (one wall switch required),
• control the light with a pull chain and the fan with a wall
switch (one wall switch required), or
• control the light with one wall switch and the fan with
another (two wall switches required).
Use connection 2, as described in Figure 12, if there is no sepa-
rate wall switch power wire for the light fixture.
NOTE: Wall switches not included.
3. Connect the wires as shown in Figure 12. To connect the wires,
twist the bare metal leads together. Place a wire nut over the
intertwined length of wire and twist clockwise until tight as.
5
Hanger Ball/
Downrod Assembly
Canopy
Adapter Cover
Set Screw
Loop
© 2007 Hunter Fan Company