Panasonic WV-NM100 Operating Instructions Manual page 28

SETUP
Network speed Common to all connection
types
HTTP port Connection type 1, 2 and 3 Use the default setting "80" for the HTTP port.
Connection type 4
Host name Connection type 1
Connection type 2
Connection type 3 and 4
BOOTP Connection type 1 and 2
Connection type 3 and 4
DHCP Connection type 1
Connection type 2
Connection type 3
Connection type 4
DNS Connection type 1
Connection type 2, 3 and 4 Set to ON when using the DNS.
Primary server Connection type 1
Secondary server Connection type 2, 3 and 4 Set the IP address of the DNS server when using the DNS.
28
Set the network speed.
Use the default setting "auto" for the network speed.
Selectable parameters: auto (default setting), 100 Mbps (full duplex),
100 Mbps (half duplex), 10 Mbps (full duplex), 10 Mbps (half duplex)
If multiple cameras are connected, it is required to set up each cam-
era individually.
However, the port numbers already assigned to other hardware are
not available. The following port numbers are also not available
because this camera already uses them.
Port number: 20, 21, 23, 25, 42, 67, 68, 69, 105, 110, 123, 161, 162,
546, 547, 5002
No setting required
Refer to your network administrator and set the designated host
name if required.
Refer to your Internet service provider and set the designated host
name if required.
Set to ON when using the "Panasonic IP Setup" software.
No setting required
Set to OFF.
Set to ON if the intranet uses the DHCP.
Set to OFF.
Set to ON if the broadband router uses the DHCP.
Set to OFF.
No setting required
Refer to your Internet service provider for the IP address of the DNS
server. Primary and secondary IP addresses can be set for the
DNS.