Invacare Jasmine JLS5 Installation And Operating Instructions Manual page 2

Install the Jasmine Scale
NOTE: For this procedure, refer to FIGURE 1, Detail "A".
The Jasmine Scale MUST be installed in the orientation shown in FIGURE 1. Otherwise, injury may
occur.
NOTE: If the scale is installed incorrectly, the swivel bar or cradle attachment will not rotate freely, limiting patient
movement during transfer.
1. Align the holes in the top rubber cap, the holes in the Jasmine scale mounting bracket and the nylon
spacers with the holes in the boom mounting bracket. Refer to Detail "A" for hardware orientation.
2. Attach the Jasmine scale to the boom mounting bracket with a screw, washer, bearings, flat washer and
locknut. Refer to Detail "A" for hardware orientation.
NOTE: Ensure the shaft of the screw passes through both sides of the boom mounting bracket.
Install the Swivel Bar or Cradle Attachment
NOTE: For this procedure, refer to FIGURE 1, Detail "B".
NOTE: The cradle attachment attaches in the same way that the swivel bar attaches to the Jasmine Scale.
1. Put the washers on the swivel bar pin.
2. Insert the swivel bar pin through the swivel bar.
3. Align the holes in the swivel bar pin with the hole in the bottom of the Jasmine scale mounting bracket.
4. Attach the swivel bar pin to the Jasmine scale with a screw and locknut. Tighten securely.
5. Snap a side rubber cap into place on each side of the boom mounting bracket.
After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is
tightened securely - otherwise injury or damage may occur.
Top Rubber Cap
Bearing
Washer
Screw
Side Rubber Cap
(2 total, 1 per side)
Jasmine™ Scale JLS5
WARNING
WARNING
DETAIL "A" -
INSTALLING THE SCALE
Boom Mounting Bracket
Locknut
Flat Washer
Bearing
Nylon Spacers
Jasmine Scale
Mounting Bracket
Jasmine Scale
FIGURE 1 Jasmine Scale
2
DETAIL "B" -
ATTACHING THE SWIVEL BAR
Screw
Washers
Swivel Bar Pin
Locknut
Swivel Bar
Part No 1152408