Invacare Pegasus Operating Manual page 37

Blink Fault
code
Power time
4
exceeded
Brake failure
5
No neutral position
6
when switching
Scooter on.
Consequence
for the Scooter
Stops driving
The maximum current was exceeded

over too long a period, probably because
the motor was overloaded or has been
working against an immovable
resistance. Switch the scooter off, wait a
few minutes and then switch on again.
The electronic system has determined a

motor short-circuit. Check the wiring
harness for short-circuit and check the
motor.
 Contact your Invacare® dealer.
Stops driving
Ensure that the disconnection lever is

pressed in.
There is a defect in the braking coil or in

the cabling. Check the magnetic brake
and cabling for open or short-circuited
circuitry. Contact your Invacare® dealer.
Stops driving
 Drive lever is not in neutral when the
keyswitch was turned. Put the drive lever
in neutral, turn the power off and then
turn on again.
It may be necessary to recalibrate the

drive lever. Contact your Invacare®
dealer.
Comments
37