Variquest Awards Maker 400 User Manual page 11

4-2
3. Open the print head by pressing down on the two release levers.
4. With the sticker side facing up, pull the media underneath the print head until
the leading edge sits on top of the rubber roller.
Note: To prevent waste, do not pull the media any further than the top of the
rubber roll.
5. Adjust the right- and left-media guides to ensure a snug fit. The media guides
can be adjusted to fit different sticker sizes.
Media Guides
6. Close the print head by firmly pressing down the print head module until you
hear a click on each side. Snap in one side at a time to ensure proper closure.
7. Close the top cover.
Release Levers
®
VariQuest Awards Maker 400 User's Guide