Trap Receivers - D-Link DES-3204 User Manual

DGS-3204 Ethernet Switch Management User's Guide
♦ Default Gateway IP Shows the IP Address of the gateway router where
packets destined for IP addresses outside of the local network should be
sent for forwarding.
♦ Phys Address Shows the physical (MAC) address of the switch.
♦ If Type Describes the type of IP Interface. The DGS-3204 supports
CSMA/CD the standard Ethernet protocol.
To change the switch's IP settings, press the Modify button in the IP Interface
Table window. The Set IP Interfaces (shown below) window will be displayed:
When all changes have been made, press Apply then restart the switch to let the
changes take effect.
NOTE Changing the IP settings may make the switch temporarily
inaccessible from the management station. Be sure to update
the switch's map entry after changing its IP address.

Trap Receivers

Your DGS-3204 Ethernet switch can send SNMP traps to network management
stations when exceptional events happen. These include:
♦ When the switch is powered on.
♦ Whenever a user-defined threshold condition occurs.
26 DGS-3204 Management