Dhcp Server - LevelOne WBR-6803 User Manual

if the device detected that the Ethernet WAN connection is recovered, your broadband
connection will be switched to use the Ethernet WAN service
2. IP Mode: Please check the IP mode your ISP assigned, and select "Static IP Address" or
"Dynamic IP Address".
3. My IP Address and My Subnet Mask: The private IP address and subnet mask your ISP
assigned to you.
4. Router IP and Server IP Address/Name: The IP address of the L2TP server and
designated Router provided by your ISP.
5. L2TP Account and Password: The account and password your ISP assigned to you. If
you don't want to change the password, keep it blank.
6. Connection ID: Optional. Input the connection ID if your ISP requires it.
7. Maximum Idle Time: The time of no activity to disconnect your L2TP session. Set it to
zero or enable "Auto-reconnect" to disable this feature. If Auto-reconnect is enabled, this
device will connect with ISP automatically, after system is restarted or connection is
dropped.
8. Connection Control: There are 3 modes to select:
Connect-on-demand: The device will link up with ISP when the clients send
outgoing packets.
Auto Reconnect (Always-on): The device will link with ISP until the connection is
established.
Manually: The device will not make the link until someone clicks the
connect-button in the Status-page.
9. Maximum Transmission Unit (MTU): Most ISP offers MTU value to users. The default
MTU value is 0 (auto).

3.1.2. DHCP Server

1. DHCP Server: Choose either Disable or Enable. If you enable the DHCP Server function,
the following settings will be effective.
27