Table of Contents
Advertisement
IP address: Sets the LAN IP addresses, and the first IP address is 192.168.1.1 by
default, while the other three IP addresses are 0.0.0.0 by default.
Subnet mask: Sets the subnet mask of the corresponding IP address, which is
255.255.255.0 by default.
MAC address: The MAC address of the LAN port. It is suggested not to modify the
MAC address of the LAN port freely.
Interface mode: Sets the duplex mode and rate for interfaces. Options are: Auto
(adaptive), 10M-FD (10M full duplex), 10M-HD (10M half duplex), 100M-FD full
duplex (100M), 100M-HD (100M half duplex). The default is Auto, which is usually not
required to be modified, and if there is any compatibility issue, or the device used
does not support auto negotiation function, then the type of Ethernet negotiation can
be set up here.
Tip:
After modifying the LAN IP address, you must use a new IP address to log into the device,
and the IP for logging into the host must be on the same network segment.
6.4
DHCP server
This section mainly introduces the Network parameters -> DHCP server page, including
http://www.level1.com
Figure 6-13 Configuration of LAN port
Chapter 6 Network parameters
Page 35
Advertisement
Table of Contents
