Basic Operation; Turning The Detector On; Discrimination Mode; To Accept All Targets - Bounty Hunter Time Ranger Owenrs Manual

Basic Operation

Turning the Detector ON

Follow these steps to turn on your Time Ranger™ detector.
1. Hold the detector with the search coil about waist high and press
the POWER ON/OFF touch pad.
The unit emits three beeps and Ar appears momentarily in the
TARGET readout, indicating that the detector is measuring the air.
2. When IR appears in the TARGET readout, lower the detector to the
ground and select from one of two Time Ranger™ modes of operation:
ALL METAL—This mode is used to detect all metals without motion.
In this mode, metals are identified by volume increases in only one
continuous medium tone.
DISCRIMINATION—This is a motion mode that allows you to
eliminate undesirable objects from detection. In this mode, metals
are identified via the LCD display and with three distinct tones. By
pressing the Disc Touch Pad after IR appears, you automatically
enter motion All Metal Mode; no metals are rejected.

DISCRIMINATION Mode

In DISCRIMINATION mode, you can accept all targets, select PRESET
targets, or program your own combination of targets to accept or reject,
operate the unit in SNIFF mode, or use the BLANKER feature. In this
mode, the detector must be in motion to detect targets.

To accept all targets

1. Perform the steps described in Turning the Detector ON section of
this manual.
POWER
SNIFF
ON/OFF
ALL METAL
SMART
TRAC
DISC
PRESET
TARGET
BLANKER
14