Dials - Bounty Hunter Time Ranger Owenrs Manual

Dials

The LCD display has five indicator/adjustment dials, as shown in the
following diagram. All are used to monitor the detector's operation; the
SENSITIVITY dial is used in conjunction with touch pads on the control
panel to adjust the detector's sensitivity and the BLANKER dial is used
in conjunction with the BLANKER touch pad to set the level at which
the detector will eliminate surface objects.
SENSITIVITY
The SENSITIVITY dial is located on the top left of the LCD display and is
used in conjunction with the LOW (-) or HIGH (+) touch pads to adjust
the Time Rangers™ sensitivity while operating in DISCRIMINATION
mode. The arrow points to the selected setting. Adjust sensitivity to
eliminate electromagnetic interference or to adjust detector depth.
DEPTH
The DEPTH dial is located on the top right of the LCD display and
indicates the depth of the detected target in a range of 2-10 inches. The
arrow points to the detected depth. When the depth exceeds 10 inches,
an arrow appears under DEEP TARGET in the PROBABLE TARGET ID
fields. Depth detection is usually accurate to eight inches or less for
coin-sized objects only.
BATT
The BATT dial is located on the bottom left of the LCD display and
indicates battery strength as follows:
G=Good
F=Fair
L=Low
R=Replace
12