Installer's Instructions To User - Thermo Pride OPA Installation And Service Manual

All installations and services must be performed by qualified service personnel.
After completing the installation, the installer shall inform and/or demonstrate to the
homeowner:
1. The location of these instructions in the appliance. These instructions must be
kept along with instructions for any accessories in the plastic pouch on the inside
of the appliance.
2. The location and use of the manual oil shutoff valve and appliance electrical
disconnecting device. The end user must be instructed to always shut off the
electric power to the appliance, before shutting off the oil supply.
3. The sequence of operation of the appliance.
4. The correct operation and maintenance of the appliance, as outlined in the
Homeowner/User Information and Routine Maintenance section of this
manual.
5. That failure to maintain and operate this appliance in accordance with these
instructions could result in hazardous conditions, property damage, and bodily
injury. It may also void the limited warranty on the appliance.
6. Review with and encourage the user to read the label reproductions and all
warnings and instructions outlined on the front cover and in Sections I, II, and III,
of this manual.
7. Recommend the user have a qualified heating contractor inspect the entire
appliance at least once a year. Inform the user of the frequency of inspection
required for each item in the Dealer Maintenance section of this manual.
8. Inform the user to maintain adequate clearances around air openings into the
appliance housing and not to block or restrict the entrance of air into the
condenser coil or the burner compartment air openings.
V. INSTALLER'S INSTRUCTIONS TO USER
46