Table of Contents
Advertisement
USB 2.0 Connector
This motherboard provides eight USB 2.0 ports to connect USB devices, such as
mouse, keyboard, modem, printer, etc. There are four ports on the back panel.
You can use proper cables to connect the Front USB connector to USB modules or
front panel of chassis.
Pin 1
1 2
Pin 1
+5V
+5V
SBD6-
SBD7-
SBD6+
SBD7+
GND
GND
KEY
NC
9 10
USB Connector
10/100 Mbps LAN onboard
On the strength of SiS LAN controller on board, this motherboard provides 10/100
Mbps Ethernet for office and home use. The Ethernet RJ45 connector is located on
top of USB connectors. The right hand side LED indicates link mode, it lights in
yellow whenever linking to network. The left hand side LED indicates the transfer
mode and it lights in green when data is transferring in 100Mbps. To enable or
disable this function, you may simply adjust it through BIOS.
Transferring (Left)
Green 100Mbps
Linking (Right)
Yellow
Front Audio Connector
If the housing is designed with an audio port on the front panel, you'll be able to
connect onboard audio to front panel through this connector. By the way, please
remove the jumper cap from the Front Audio Connector before you connect the
cable. Do not remove this yellow jumper cap if your housing doesn't have an audio
port on the front panel.
Pin 1
1
AUD_GND
AUD_MIC
AUD_VCC
AUD MIC BIAS
AUD_RET_R
AUD_FPOUT_R
KEY
NC
AUD_FPOUT_L
AUD_RET_L
Front Audio Connector
S/PDIF Connector
S/PDIF (Sony/Philips Digital Interface) is a newest audio transfer file format,
which provides impressive audio quality through optical fiber and allows you to
enjoy digital audio instead of analog audio. Through a specific audio cable, you can
connect the S/PDIF connector to other end of the S/PDIF audio module, which
bears S/PDIF digital output. Normally there are two S/PDIF outputs as shown, one
for RCA connector, the most common one used for consumer audio products, and
the other for optical connector with better audio quality. Same as outputs, you can
also connect RCA or optical audio products to input connectors on the module and
have the voice or music come out from your computer. However, you must have a
S/PDIF supported speaker/amplifier/decoder with S/PDIF digital input/output to
connect to the S/PDIF digital input/output to make the most out of this function.
S/PDIF
(RCA)
1
Cable
S/PDIF OUT
S/PDIF IN
S/PDIF OUT
S/PDIF IN
(Optical)
5
S/PDIF Connector
S/PDIF Module
(User Upgrade Optional)
Pin 1
+5V
KEY
SPDIF OUT
GND
SPDIF IN
Advertisement
Table of Contents
