Table of Contents
Advertisement
1. Installing CPU
This socket supports FC-LGA4 CPU, which is the latest CPU package developed by
Intel. Other forms of CPU package are impossible to be fitted in.
CPU socket plate
Plastic cap
Socket Pin 1
CPU socket lever
Golden arrow
2. Installing CPU & System Fans
Plug in the CPU fan cable to the 4-pin CPUFAN connector. If you have chassis fan,
you can also plug it in SYSFAN1 or SYSFAN2 connector.
GND
+12V
SENSOR
SYSFAN2 Connector
1.
Pull CPU socket lever and plate up.
2.
Remove
plastic
cap
from
socket plate.
3.
Locate Pin 1 in the socket and look
for a golden arrow on the CPU
upper interface. Match Pin 1 and
golden arrow. Then insert the CPU
into the socket.
4.
Press down CPU socket plate and
lever to finish CPU installation.
Warning: If you do not match the CPU
socket Pin 1 and CPU golden arrow well, you
may damage the CPU. And please don't
touch CPU socket pins when installing CPU.
Note: It's strongly recommended by
Intel to use thermal paste properly to avoid
over-heat generated from Prescott CPU.
SENSOR
+12V
GND
SYSFAN1 Connector
PWM
SENSOR
+12V
GND
CPUFAN Connector
Note: Some CPU fans
do not have sensor pin so
they cannot support fan
monitoring.
3. Installing Memory Modules
DIMM slots are designed in Electronic blue which are very easy to recognize. Insert
the module straight down to the DIMM slot with both hands and press down firmly
until the DIMM module is securely in place.
CPU
Tab
4. Connecting IDE and Floppy Cables
Connect 34-pin floppy cable and 40-pin, 80-wire IDE cable to floppy connector FDD
and IDE connector. Be careful of the pin1 orientation. Wrong orientation may cause
system damage.
Pin 1
FDD Connector
Pin 1
Key
Note: The tabs of
the DIMM slot will
close-up to hold the
DIMM in place when
the DIMM touches the
slot's bottom.
Secondary
Secondary
Slave (4th)
Master (3rd)
IDE 2 (Secondary)
Pin 1
IDE 1 (Primary)
Primary
Primary
Master (1st)
Slave (2nd)
ATA 66/100/133
IDE Connector
Advertisement
Table of Contents
