Interior Theft Sensor (It-S); Security System Will Not Arm - Ford Gen-2 Gold Owner's Manual

System Operation (Con't)
The alarm cycle lasts for 30 seconds. At the end of the 30 second cycle, the system
will pause for 10 seconds and then begin monitoring for any further alarm
conditions. If another alarm condition is detected the system will go in to another
alarm cycle. The system will trip up to 5 times for each different alarm condition (i.e.
door open or hard impact to the vehicle body)

Interior Theft Sensor (IT-s):

While the security system is armed, the IT-s monitors for impact to both the vehicles
body and glass. If a light, not-threatening, impact is detected the system will chirp
the horn to warn-away would be intruders. In the event that a hard impact is
detected, the system will trip an alarm cycle.
Temporarily overriding the IT-s :
Pressing* the button on your PowerCode remote control transmitter within 5
seconds of arming the security system will disable the Interior Theft Sensor (IT-s)
for that arming cycle. The system will confirm this command by chirping the horn
three times. Rearming the security system will re-enable the IT-s.
Automatic arming**:
Your PowerCode security system can be programmed to arm and/or lockout the
starter automatically. Your PowerCode security system is programmed from the
factory for manual arming. If you would like to activate the automatic starter lockout
and/or automatic arming features of your system, contact 1-800-FORD-KEY for
instructions on activating these and your systems other programmable features.
When automatic arming is activated, one minute after the ignition key has been
turned off (if all entry points are closed) the system will flash the parking lights two
times to indicate the security system is armed.

Security system will not arm:

If the parking lights only flash** once when you attempt to arm the security system
and the horn only chirps once when the is pressed* a second time, the security
system is either in Valet mode or a protected entry point is open. If a entry is open
when the system attempts to arm, the system will wait up to 5 minutes for the open
entry point to be closed. If the entry is still open after five minutes, the system will go
ahead and arm, ignoring the open entry point until after it is closed. Once closed that
entry point will then be monitored. If all of your doors are closed, the system is in
Service/Valet mode. In this case, refer to the "Service/Valet mode" section of this
manual.
* "Press" refers to pushing a transmitter button for approximately one second.
** See your dealer for details on available installation features and options.
10
Gen-2 Gold Owners, 1031555 RevA - TRANSLATED.pmd 10 6/14/2006, 2:45 PM