Mounting The Remote Thermo Sensor - Radio Shack 43-939 Owner's Manual

43-939.fm Page 16 Tuesday, June 6, 2000 8:09 AM
MOUNTING THE REMOTE THERMO
SENSOR
You can place the remote sensor on a flat surface using the
supplied wire stand, or mount it on the wall using two screws
(not supplied) and the supplied bracket.
Selecting a Location
Choose an indoor or outdoor location that is within 60–90 feet
(20–30 meters) of the Caller ID module.
The construction of your home or office might affect the trans-
mission range between the Caller ID module and the remote
thermo sensor. If you have a choice of several locations, try
each to see which provides the best performance.
Caution: Do not place the sensor:
• where it will be in direct sunlight
• in water (it is weather-resistant, not waterproof)
• near electrical appliances or heating or air conditioning
vents
Using the Stand
To set the sensor on a flat surface, insert
the ends of the supplied wire stand into the
holes on the back of the sensor.
16
Preparation