Installing The Canopy - Hunter TYPE 7 Installation And Operation Manual

5-1. Partially install two canopy screws into the ceiling plate and one
time.
5-2. Holding the canopy, raise the fan off the hook.
5-3. Align the slots in the canopy with the already partially installed
canopy screws on the ceiling plate.
5-4. Raise the canopy over the ceiling plate. Rotate the canopy
clockwise until the canopy screws on the ceiling plate totally
engage with the slots in the canopy.
5-5. Install the third canopy screw into the canopy. Once all three
screws are in, tighten them.
5-6. Lift the fan housing toward the ceiling and rotate the fan until
each canopy tab engages a groove in the hanger ball.
Note: If the tabs are already engaged, do not rotate.
5 • Installing the Canopy
Canopy
Screw
8
42772-01 • 05/06/08 • Hunter Fan Company
Step 5-2
Canopy
Step 5-3
Steps 5-4 – 5-5
Hanger
Ball
Ceiling Plate
Ceiling Plate
Canopy
Screw