With A Light Fixture - Hunter TYPE 7 Installation And Operation Manual

7 • Completing Your Installation With a Light Fixture
Your Hunter fan comes with an integrated light fixture assembly.
WARNING: Use only the light fixture supplied with this fan model.
The switch housing assembly is made up of three sections: the switch housing gas-
ket, the upper switch housing, and the lower switch housing/light assembly.
ATTACHING THE SWITCH HOUSING GASKET
AND UPPER SWITCH HOUSING
7-1. Locate the switch housing mounting plate, the switch housing gasket and
the upper plug connector.
NOTE: Your fan may come with the switch housing gasket attached to the
switch housing mounting plate.
If the switch housing gasket is attached to the switch housing mounting
plate, go to the section "Attaching the Upper Switch Housing."
If the switch housing gasket is not attached complete the steps below.
7-2. Identify the top side of the switch housing gasket by looking for the raised
circular ridge on the gasket.
7-3. With the top side of the switch housing gasket facing up towards the mo-
tor, align the holes in the gasket with the spokes on the switch housing
mounting plate.
7-4. Feed the upper plug connector through the center opening of the upper
switch housing gasket. Push the gasket up so that it is seated flush with
the mounting plate .
10
42772-01 • 05/06/08 • Hunter Fan Company
Gasket
Step 7-1
Holes
Step 7-3
Mounting
Plate
Upper
Plug
Spokes