Table of Contents
Advertisement
SPECIAL MOBILE HOME REQUIREMENTS:
WARNING: DO NOT INSTALL IN A SLEEPING ROOM.
An outside air source must be connected to the stove and can be brought in through the sidewall
or vented crawl space. Flexible or rigid pipe should be used and will connect to the adaptor on
the back of the stoves. (See air inlet location below).
CAUTION: When installing the stove in a mobile home, care must be taken not to interfere
with the structural integrity of the mobile home. Floor, wall and ceiling/roof integrity must be
maintained. When installed in a mobile home, this appliance must be grounded to the steel
chassis of the frame with 12 gauge or larger diameter wire. This appliance must also be bolted to
the floor in compliance with and according to H.U.D. requirements, unless not required by local
authority. The pedestal model comes with a hole pre-drilled in the base for bolting. The leg
model requires a pre-drilled mounting bracket. Connect one end of the bracket to one of the
back legs using the same bolt used to fasten the leg to the stove. Secure the other end to the
floor. (See diagram below) (Mounting bracket ref. #DV 315)
REAR VIEW WITH PEDESTAL
___________________________________________________________________
Outside air can be drawn through the floor or through the sidewall.
MOBILE HOME REQUIREMENTS
REAR VIEW WITH LEGS
(6)
Hide quick links:
Advertisement
Table of Contents
