Table of Contents
Advertisement
CLEANING INSTRUCTIONS...continued
WARNING: DISCONNECT THE POWER CORD BEFORE CLEANING OR
SERVICING THIS UNIT. THE STOVE MUST BE TURNED OFF AND COOLED
BEFORE USING THE RAKE HANDLE.
ASH RAKE HANDLE
II. HEAT EXCHANGER:
This stove is designed with a built-in heat exchange tube
Rake. The ash handle is located on the front of the stove
and is moved backwards and forwards several times
to remove the buildup of ash. After cleaning, push the
rake handle in until it stops.
III. COMBUSTION BLOWER:
Over the course of the heating season dust and ash may collect on the blades of the combustion
blower. Periodically they should be inspected and vacuumed clean. The combustion blower is
accessed by removing the stove's right side panel and then removing the inspection caps or the
exhaust manifold cover (See figure below). Never operate the stove without the inspection cap
or manifold cover in place.
(16)
Hide quick links:
Advertisement
Table of Contents
