Connecting To Car Kit Phones - HTC Tilt 2 User Manual

9.6 Connecting to Car Kit Phones

Bluetooth car kit phones that support the SIM Access Profile (SAP) can connect to
your device and access its SIM card via Bluetooth. Once a SAP connection has been
established, you can download device and/or SIM contacts from your device to the
car kit phone, and use the car kit phone to answer and make calls.
1. Tap Start > Settings > Bluetooth.
2.
Turn Bluetooth on and set your device to visible mode. For instructions, see
"To turn Bluetooth on and make your device visible" earlier in this chapter.
3. On the Settings tab (
4. Scroll down and tap SIM Access.
5. Select the Enable SIM Access Profile (SAP) check box, and then tap Done.
6.
Connect the car kit phone to your device via Bluetooth. For instructions, refer
to your car kit phone's manual.
7.
If this is the first time you are pairing the car kit phone with your device, enter
the car kit phone's passcode on your device.
8.
A pop-up message should appear on your device saying that a connection
has been established between your device and car kit phone. Tap OK.
Note
You are not able to make and receive calls, send and receive messages, or perform
related activities on your device when the SIM Access Profile connection is active.
You are able to make or receive calls from the car kit phone during this time. After the
connection is disconnected, you will be able to use your device as before.
), tap Advanced.
Bluetooth 189