LG WM1333HW Training Manual page 32

DISASSEMBLY
CLEAN THE DRAIN PUMP FILTER
Allow the water to cool down before cleaning the drain pump filter.
1) Open the lower cover cap () with a tool such as coin. Turn the drain
plug () to pull out the hose.
2) Unplug the drain plug (), allowing the water to flow out. At this time
use a vessel to prevent water from flowing onto the floor. When water
does not flow any more, turn the pump filter () open to the left.
3) Remove any foreign objects from the pump filter (). After cleaning,
turn the pump filter () clockwise and insert the drain plug () to the
original place. Close the lower cover cap().
DRAIN PUMP
1) Remove pump outlet hose.
2) Remove tub pump bellows.
3) Remove cap (Remaining Hose.)
4) Disconnect the wiring.
5) Unscrew 2 screws.
6) Remove the pump.
HEATER ASSEMBLY
1) Loosen the M6 heater nuts to pull out the
HEATER ASSEMBLY.
CAUTION: When mounting the HEATER ASSEMBLY
be sure to insert the HEATER ASSEMBLY into the
heater clip on the bottom of the tub.
THERMISTOR
1) Pull it out by holding the THERMISTOR
bracket.
2) If it is pulled by the wire, it may be broken.
3) When mounting the THERMISTOR again, make
sure that it is got back tight to the bushing.
Series 33 Washer Training
32
0 1 0
2 3
3
2
Disassembly