LG WM1333HW Training Manual page 22

TROUBLESHOOTING
SPIN PROBLEMS
Series 33 Washer Training
Check on the spinning, is the frequency of the water
level 248 or more. The frequency can be checked by
pressing the Time Delay and Quick Cycle
buttons at the same time on the program.
When pressing Stain Cycle, Soak and POWER
buttons at the same time after power off, press the
Start/Pause button 2 times, is the drum low speed
spin?
Is it disconnected, or disassembled?
[Black : 2pin( ), Yellow: 2pin( ), Red : 3pin( ),
Blue : 6pin( )]
Is it disconnected, or disassembled?
[White : 3pin ( ), National : 4pin ( )]
Check the motor connector, Is the resistance of the
terminal same as the figure?
MOTOR TERMINAL (1)
Resistance of terminal :
~ / ~ / ~ : About 5Ω ~ 10Ω
Replace the MAIN PWB ASSEMBLY
22
Check the sensor
(Pressure) or hose
(Sensor). If the problem is
on the sensor or the hose,
replace the sensor or the
hose.
Normal
Correct the connector
Correct the connector
Replace the Stator
Assembly
(4417EA1002D)
Troubleshooting