Char-Broil 463261709 Product Manual page 15

5
On back of grill, place upper back panel between side panels and
above lower back panel. Secure upper back panel, in lower holes,
using one 1/4-20x1½" screw, 7mm lock washer, and 7mm flat
washer on each side. Do not fully tighten screws until side shelf
installation is complete in later steps.
6
Insert flange on right side shelf into side shelf brackets on side of firebox.
Attach right side shelf using three 1/4"-20x3/4" screws, 7mm lock washers, 7mm flat washers, 1/4" nuts, shown A.
Attach rear of shelf using one 1/4-20x1½" screw, 7mm lock washer, and 7mm
Attach front of shelf and fascia using one #8x3/8" self-tapping screw and large
Attach front of shelf and fascia using one 1/4"-20x3/4" screw, 7mm lock washer, 7mm flat washer and 1/4" nut, shown D/C.
Bracket
Main control
panel
7mm flat
washer
Fascia, right side shelf
1/4"nut
7mm lock
washer
Upper back panel
B
1/4-20x1½"
screw
7mm lock
washer
screw
7mm flat washer
1/4-20x1½" 7mm lock 7mm flat
screw washer washer
flat washer in lower hole, shown B.
flat washer, shown C.
1/4"nut
7mm lock
washer
D
Back of main control panel
C
A
1/4-20x3/4"
screw
7mm flat
washer
Igniter Switch
1/4-20x3/4"
screw
15