Advertisement
3
Loosely install handle brackets (9) with screws (15), spacers
(12) and nuts (14). Position heat plate (5) over screws so nuts
are on inside of plate flanges. Tighten screws.
4
From inside of lid, attach resin handle (1) using screws (13)
and washers (17). From inside of lid, install 2 hinge brackets
(3) using bolts (16), and nuts (14). Be sure slots in brackets
face the same direction.
5
Before assembly, inspect regulator for damage, dirt or debris
accumulation. Clean out if present.
With knob
pointing down
burner.
must
Notch in regulator
Once regulator has
completely engaged
regulator
clockwise
to lock in position with knob pointing up.
, insert regulator (10) into end of
engage dimple in end of burner.
burner, turn
Advertisement
