Thermos 461630510 Product Manual page 21

Burner, Firebox and Control Knob
9 9
'
Place burner assembly into firebox. Fasten the burner assembly to the firebox using 5x15 fiber washers and
#10-24x1/2'' machine screws. Insert #10-24x1-1/4'' machine screws from outside the firebox, then fasten with #10-24
flange nuts and 5x15 fiber washers from the inside (A).
'
Place firebox on cart. Make sure burner tubes are correctly engaged with valves. If burner is not level from left to right,
adjust the two screws attaching valve to control panel. Attach ignitor wire to ignitor (B).
'
Attach firebox with #10-24x2'' machine screws, 5x15 fiber washers and #10-24 wing nuts .
'
Push control knobs onto valve stems (C).
Burner assembly
A
5x15 Fiber Washer
5x15 Fiber Washer
#10-24x2'' Machine Screw
5x15 Fiber Washer
Control Knob
Firebox
#10-24 Flange Nut
#10-24X1/2''
Heat shield
Machine Screw
C
#10-24 Flange Nut
#10-24X1-1/4''
Machine Screw
B
for Tank
Valve
Venturi tube
Make sure the Venturi tubes are located
#10-24 Flange Nut
Qty.8
#10-24x1-1/4"
Machine Screw
5x15 Fiber Washer
Qty.10
Ignitor wire
underneath Heat Shield
#10-24x1/2"
Machine Screw
Qty.2
#10-24x2"
Machine Screw
Qty.4
Qty.4
21