Error Messages - HP PROCURVE 6120 Management And Configuration Manual

Port Status and Configuration
Viewing Port Status and Configuring Port Parameters
ProCurve(config)# show int custom 1-4 port name:4 type vlan intrusion speed
enabled mdi
Status and Counters - Custom Port Status
Port Name
---- ---------- ---------- ----- --------- ------- ------- --------
1 Acco
2 Huma
3 Deve
4 Lab1
Figure 10-6. Example of the Custom show interfaces Command
N o t e
10-12
Type VLAN
100/1000T 1
100/1000T 1
100/1000T 1
100/1000T 1
You can specify the column width by entering a colon after the column name,
then indicating the number of characters to display. In Figure 10-6 the Name
column only displays the first four characters of the name. All remaining
characters are truncated.
Each field has an fixed minimum width to be displayed. If you specify a field
width smaller than the minimum width, the information is displayed at the
minimum width. For example, if the minimum width for the Name field is 4
characters and you specify Name:2, the Name field displays 4 characters.
Parameters can be entered in any order. There is a limit of 80 characters per
line; if you exceed this limit an error displays.

Error Messages

Error
Requesting too many fields (total characters
exceeds 80)
Field name is misspelled
Mistake in specifying the port list
The port list is not specified
Intrusion
Alert Speed
No 1000FDx Yes
No 1000FDx Yes
No 1000FDx Yes
No 1000FDx Yes
Error Message
Total length of selected data exceeds one line
Invalid input: <input>
Module not present for port or invalid port:
<input>
Incomplete input: custom
Enabled MDI-mode
Auto
Auto
Auto
Auto