HP ProCurve Series 6600 Installation And Getting Started Manual page 47

4.
5.
6.
7.
Here is some information on the fields in the Setup screen. For more
information on these fields, see the Management and Configuration Guide,
which is on the ProCurve Web site at www.procurve.com/manuals:
Parameter Default
System Name blank
System Contact blank
Manager Password blank
Logon Default CLI
Time Zone 0 (none)
Community Name public
Spanning Tree Enabled No
Default Gateway blank
Time Sync Method None
TimeP Mode Disabled
IP Config (DHCP/Bootp) DHCP/Bootp
IP Address xxx.xxx.xxx.xxx Recommended; If you set IP Config to Manual, then enter an IP address
Note: The IP address and subnet mask assigned for the switch must be compatible with the IP addressing used in your
network. For more information on IP addressing, see the Management and Configuration Guide, which is on the ProCurve
Web site at www.procurve.com/manuals.
Subnet Mask xxx.xxx.xxx.xxx Recommended; If you entered an IP address, then enter a subnet mask
to the IP Config (DHCP/Bootp) field and use the Space bar to select the
[Tab]
Manual option.
to the IP Address field and enter the IP address that is compatible with
[Tab]
your network.
to the Subnet Mask field and enter the subnet mask used for your
[Tab]
network.
Press [ (for Save).
Enter] , then [S]
Optional; up to 25 characters, including spaces
Optional; up to 48 characters, including spaces
Recommended; up to 16 characters (no blank spaces)
The default setting selects the command line interface for console access.
The alternative is the menu interface.
Optional; 1440 to -1440. The number of minutes your location is to the West (-)
or East (+) of GMT.
Default setting recommended.
Default setting recommended unless STP is already running on your network
or the switch will be used in complex network topologies.
Optional; Enter the IP address of the next-hop gateway node if network traffic
needs to be able to reach off-subnet destinations.
Optional; The protocol the switch uses to acquire a time signal. The options
are SNTP and TimeP.
Optional; The method the switch uses to acquire the TimeP server address.
Set to Manual unless a DHCP/Bootp server is used on your network to
configure IP addressing.
compatible with your network.
compatible with your network.
Getting Started With Switch Configuration
Using the Console Setup Screen
3-3