Connect The Network Cables; Using The Rj-45 Connectors; Connecting Cables To Mini-Gbics - HP ProCurve Series 6600 Installation And Getting Started Manual

Procurve 6600 series switches
Hide thumbs Also See for HP ProCurve Series 6600:
Table of Contents

Advertisement

Installing the Switch
Installation Procedures
To remove the mini-GBICs that have the plastic tab or plastic collar, push the
tab or collar toward the switch until you see the mini-GBIC release from the
switch (you can see it move outward slightly), and then pull it from the slot.
To remove the mini-GBICs that have the wire bail, lower the bail until it is
approximately horizontal, and then using the bail, pull the mini-GBIC from the
slot.

7. Connect the Network Cables

Connect the network cables, described under "Cabling Infrastructure"
2-5), from the network devices or your patch panels to the fixed RJ-45 ports
on the switch or to any mini-GBICs you have installed in the switch.

Using the RJ-45 Connectors

To connect:
Push the RJ-45 plug into the RJ-45 jack
until the tab on the plug clicks into
place. When power is on for the switch
and for the connected device, the Link
LED for the port should light to confirm
a powered-on device (for example, an
end node) is at the other end of the
cable.
If the Link LED does not go on when the
network cable is connected to the port,
see
page
shooting".
To disconnect:
Press the small tab on the plug and pull
the plug out of the jack.

Connecting Cables to mini-GBICs

N o t e
Each of the four mini-GBIC slots is shared with the associated 10/100/
1000Base-T RJ-45 port. If a mini-GBIC is installed in a slot, the associated RJ-
45 port is disabled.
If you have any mini-GBICs installed in the switch, the type of network
connections you will need to use depends on the type of mini-GBICs you have
installed. See Appendix B,
GBIC cabling information.
2-18
"Diagnosing with the LEDs" on
5-4, in chapter 5, "Trouble-
"Cabling and Technology
Unshielded twisted-pair cable:
• Category 3, 4, or 5 for 10 Mbps ports
• Category 5 or better for 100 Mbps ports
• Category 5e or better for 1000 Mbps ports
Maximum distance: 100 meters
Figure 2-13. Connecting RJ-45s
Information", for the mini-
(page
RJ-45
connector

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents