Installing The Switch; Included Parts - HP ProCurve Series 6600 Installation And Getting Started Manual

Installing the Switch

The HP ProCurve Series 6600 Switches come with an accessory kit that
includes the brackets for mounting the switch in a standard 19-inch telco rack,
or in an equipment cabinet. The brackets are designed to allow mounting the
switch in a variety of locations and orientations. For other mounting options
contact your local ProCurve authorized network reseller or ProCurve repre-
sentative. This chapter shows how to install the switch.
C a u t i o n
If the switch is to be shipped in a rack, be sure to use only an HP 10K rack.
Mount the switch using rail mounting kit, (5070-6532). The switch warranty
may be voided.

Included Parts

The Series 6600 Switches have the following components shipped with them:
■
■
■
■
■
■
■
HP ProCurve Switch Quick Setup sheet
HP ProCurve Switches General Safety and Regulatory Information
booklet
Series 6600 Switch Safety and Regulatory Information sheet
Read Me First
Customer Support/Warranty booklet
Console cable
Accessory kits
5070-6315 used with the
J9263A and J9264A
two mounting brackets
eight 8-mm M4 screws to attach the
mounting brackets to the switch
four 5/8-inch number 12-24 screws to
attach the switch to a rack
Installing the Switch
5070-6316 used with the
J9265A
two mounting brackets
eight 8-mm M4 screws to attach the
mounting brackets to the switch
four 5/8-inch number 12-24 screws to
attach the switch to a rack
Included Parts
2
2-1