4.
Figure 2-9. Sliding the switch into the rails
5.
Figure 2-10. Mounting in a rack
C a u t i o n
Make sure the air flow is not restricted in the front or back of the switch. See
Figure 2-1 on
Slide the switch into the rails
Hold the switch with attached brackets up to the rack and move it
vertically until rack holes line up with the bracket holes, then insert and
tighten the four number 12-24 screws holding the brackets to the rack.
page 2-4
for the air flow direction.
Installing the Switch
Installation Procedures
2-13